Sewing Machine Instructions
Page 6
Feed the thread through the
6.
hole in the needle holder
and then through the eye of
the needle. (Figure 14) The
threading is now complete,
except for the bobbin.
Connecting the bobbin
Remove the Bobbin Cover. (Figure 15)
1.
Place the bobbin into the Bobbin Case,
2.
(Figure 16) making sure that the thread
unwinds in a clockwise direction. Allow
approximately 4 inches of thread to extend
from the case.
Extend about 4 inches of thread from the
3.
machine’s needle. (Figure 17)
Raise the presser foot. Hold the thread from
4.
the needle with your left hand while turning
the hand wheel with your right hand counter-
clockwise (toward you). (Figure 18)
Keep rotating the wheel till the needle goes
5.
through the plate down to the Bobbin Case
and then back up again. When the needle
comes back up, it will pull a loop of bobbin
thread with it.
Pull at the loop to get the raw
6.
edge of the bobbin thread
farther out of the Bobbin
Case. (Figure 19)
Figure 18
Figure 19
Figure 15
Figure 16
Figure 17
Figure 14
Figure 13