10
Using the control panel (continued)
Programming the Single or Double pours
The program function allows the coffee maker
to personalise and save their own espresso
pour settings.
To program the ‘SINGLE’ and ‘DOUBLE’
coffee pours the espresso machine needs to
be in STAND BY MODE (so the machine is
plugged in and turned on at the wall, but
the power on the machine has not yet been
turned on).
To activate the program function for the
‘SINGLE’ and ‘DOUBLE’ espresso pours, the
coffee maker needs to press and hold down
both the ‘SINGLE’ and ‘DOUBLE’ buttons.
While still holding down these two buttons
briefly press the ‘POWER’ button and release
all buttons. When in programming mode the
lights around the ‘SINGLE’ and ‘DOUBLE’
buttons will slowly flash (dimming up and
down).
Depending on which pour you want to
program, press either the ‘SINGLE’ or
‘DOUBLE’ espresso pour buttons, upon
release the pour will begin.
Note:
For best results the coffee make should
only make changes to the ‘SINGLE’ and
‘DOUBLE’ coffee pour volumes by engaging
the coffee handle fitted with either the single
or double basket, packed with coffee.
When the desired pour amount has been
reached press the flashing coffee button
to set the new volume. A long beep will
sound confirming the program saved and the
machine will go into ‘READY MODE’.
Note:
For more detailed information on
programming refer to page 17 ‘Programming
your espresso machine’.
Steam
The steam function allows the coffee maker
to produce steam out of the steam wand for
texturing milk.
To activate the steam function, the coffee
maker simply needs to press the ‘STEAM’
button. By design the temperature of the
espresso machine will adjust as necessary.
There may be a short delay while you wait.
Note:
When the coffee maker has activated
the steam function the light around the
‘STEAM’ button will show a constant red
light and the light behind the ‘MANUAL’,
‘SINGLE’ and ‘DOUBLE’ buttons will go off.
Additionally the light on the ‘POWER’ button
will remain on.
Note:
If the light behind the ‘STEAM’ button
is flashing it means the espresso machine
is adjusting the temperature of the heating
system. You will be able to use the steam
while it is heating up but this is not advised
as the steam will be wetter than if the
machine is fully heated up.
Once the espresso machine is heated to the
correct temperature, so the light behind the
‘STEAM’ button stops flashing and shows a
constant red light, the coffee maker is able to
use the espresso machine.
The coffee maker simply needs to turn
the steam and hot water control dial anti-
clockwise to the ‘MAX’ setting to start and
turn it back to the ‘OFF’ position to stop.
Press the 'STEAM' button again to deactivate
the steam function.
Note:
When you have finished steaming,
ensure the steam and hot water control dial
is fully turned off. If the steam and hot water
control dial is left open, the coffee maker
will not be able to switch to the ‘COFFEE’ or
‘HOT WATER’ functions.
Содержание Espresso Vita EM6200
Страница 2: ......
