Sun Microsystems W1100z, Руководство пользователя

Страница: 19 / 106

Chapter 1 Introduction to the Sun Java Workstation W1100z and W2100z 1-9
1.4 Powering the Workstation On and Off
1.4.1 Powering On the Workstation
After making sure that you have set up the system properly and connected all the
required cables as shown in the
Sun Java Workstation W1100z and W2100z Getting
Started Guide, 817-6584- xx , you can now power on your system.
Tip –
If you are installing optional internal components such as additional memory
DIMMs, PCI cards, optical drives, or hard drives, install those components before
you power on the workstation. See
Chapter 4 for remove and replace procedures. If
you are not installing optional components, you are ready to power on the
workstation.
Follow these steps to power up the workstation:
1. Turn on power to the monitor and to all external devices.
2. Press and release the workstation Power button on the front panel (
FIGURE 1-1
) .
3. After several seconds, verify that the platform power LED on the Power button is
lit.
The platform power LED on the Power button lights after the workstation begins the
internal booting process (
FIGURE 1-1
).
4. If you are powering on the workstation for the first time, you will need to install
the operating system after the system has finished booting.
See Section 1.2.1, “Operating System Software” on page 1-3 for more details.
If you need to change the system parameters in the BIOS, press the F2 key during
the POST process to access the BIOS Setup Utility.
Caution –
Be careful when making changes to the system BIOS, as certain changes
can cause your system to malfunction.