Sun Microsystems Sun HPC 3.0, Руководство пользователя

Страница: 27 / 67

CHAPTER
3
Configuring the SCI Network Interface
This chapter explains how to configure the SCI network interface in a Sun HPC 3.0
cluster. It covers the following procedures:
4
Creating a temporary network map for later reference – See “Create a Temporary
Network Map for Later Reference” on page 19
4
Creating the SCI configuration file,
sci_config.hpc
– See “Create
sci_config.hpc
” on page 20
4
Running
sm_config
to initialize the SCI network interface – See “Propagate the
SCI Configuration” on page 28
4
Verifying the rank of the SCI interfaces – “Verify the Rank of the SCI Interface”
on page 29
4
Rebooting the cluster nodes – “Reboot Nodes” on page 29
The first section, “Preconditions” on page 17, describes a few conditions that must be
in effect before the SCI interface can be configured.
Preconditions
Ensure that the conditions described below are in effect before proceeding with the
SCI setup procedure.
SCI Network Hardware Must Be Installed
The SCI network hardware must already have been installed.
17