Sun Microsystems Sun Fire X2100, Руководство пользователя

Страница: 20 / 134

1-8 Sun Fire X2100 Server User Guide • April 2007
1.4 Powering the Server On and Off
1.4.1 Powering On the Server
After making sure that you have set up the system properly and connected all the
required cables as shown in the
Sun Fire X2100 Server Getting Started Guide, 819-3720,
you can power on your system.
Tip –
If you are installing optional internal components such as additional memory
DIMMs, PCI cards, optical drives, or hard drives, install those components before
you power on the server. See
Chapter 4 for removal and replacement procedures. If
you are not installing optional components, you are ready to power on the server.
Follow these steps to power on the server:
1. Turn on the power to the monitor and to all external devices.
2. Press and release the server Power button on the front panel (see
FIGURE 1-1
) .
3. After several seconds, verify that the power LED next to the Power button is lit.
The power LED lights after the server begins the internal booting process
(
FIGURE 1-1
).
4. If you are powering on the server for the first time, you need to install the
operating system after the system has finished booting.
See Section 1.2.1, “Operating System Software” on page 1-3 for more details.
If you need to change the system parameters in the BIOS, press the F2 key during
the Power-on Self Test (POST) process to access the BIOS Setup Utility.
Caution –
Be careful when making changes to the system BIOS, as certain changes
can cause your system to malfunction.