Sun Microsystems Sun Fire X2100 M2, Руководство по обслуживанию

Страница: 63 / 128

Chapter 4 Maintaining the Sun Fire X2100 M2 Server 4-17
9. Install the SAS hard drives.
See Section 4.5.3.2, “Installing an HDD and Carrier” on page 4-13 .
4.5.4.2 Installing the LSI Card to Support SATA RAID
This section describes how to add the LSI PCIe card and cables to a system using
SATA hard disks. The LSI card will support SATA hard disks attached to it. This
configuration will only be used for customers who require a true SATA RAID
configuration.
You will need to order the following components:
■
An LSI PCIe card
■
Two SATA HDDs (if not already installed)
The following procedure describes how to add the LSI PCIe card and cables to
connect to the SATA hard disks.
1. Power off the system and remove the cover as described in Section 4.3, “Powering
Off the Server and Removing the Cover” on page 4-3 .
2. Reroute the hard drive cables. See
FIGURE 4-14
.
Note the following guidelines for cable removal and installation:
■
Disconnect the red cable from the hard drive backplane and the motherboard
connector, then connect the red cable to the HDD 0 backplane.
■
Disconnect the blue cable from the hard drive backplane and the motherboard
connector, then connect the blue cable to the HDD 1 backplane.
■
Make sure to route the blue cable through the dual blower routing clips.