Sun Microsystems Sun Expert3D, Руководство по установке

Страница: 26 / 54

10 Sun Expert3D Graphics Card Installation Guide • September 2000
Installing the Sun Expert3D Card in a
Sun Enterprise 450 Server
The Sun Enterprise 450 Server supports up to three Sun Expert3D cards.
The Sun Expert3D Installation Kit for your Sun Enterprise 450 is accompanied by a
Fan Card Installation Kit. The Fan Card Installation Kit includes:
■
Sun Expert3D-F Fan Card
■
Sun Expert3D multiview cable (longer for multiple card configurations)
The Sun Expert3D graphics card connects into the 66-Mhz or 33-Mhz PCI connector
on the Sun Enterprise 450 motherboard. Each Sun Expert3D card requires a fan card
in the adjacent PCI slot below the Sun Expert3D card. See
TABLE 2-1
for the Sun
Expert3D card and fan card configuration options.
1. Shut down your system and remove the Enterprise 450 enclosure.
2. Attach the antistatic wrist strap,
3. If necessary, remove the system rear panel filler panel.
4. Insert the Sun Expert3D card into the appropriate slot on the main logic board
(
FIGURE 2-6
).
a. Insert the left side of the Sun Expert3D card into the selected opening on the
rear panel. At the same time, insert the right side of the card into the
corresponding groove on the CPU cage.
TABLE 2-1
Sun Expert3D and Fan Card PCI Slot Configuration for Sun Enterprise 450
Number of Expert3Ds Sun Expert3D and Fan Card Configuration
One Expert3D Sun Expert3D card: use one of the following 66Mhz slots: 4, 5, or 6
Fan card: use adjacent slots: 3, 4, or 5, respectively.
Two Expert3Ds Sun Expert3D card: use 66Mhz slots 4 and 6.
Fan card: use adjacent slots: 3 and 5.
Three Expert3Ds Sun Expert3D card: use slots 2 (33Mhz), 4 (66Mhz), and 6 (66Mhz).
Fan card: use adjacent slots: 1, 3, and 5.