Chapter 3
Installing the Sun Expert3D Software
23
8. Shut down the system after Sun Expert3D software is installed:
See the
shutdown(1M)
and
boot(1M)
manual pages for more details.
9. Reboot the system at the
ok
prompt to complete the installation:
*** Installing Sun Expert3D support for Solaris 7...
*** Installing fbconfig...
*** Installing Sun OpenGL 1.2...
*** Installing Sun OpenGL 1.2 support for Sun Expert3D...
*** Installation complete.
To remove this software, use the ’remove’ script on this CDROM, or
the following script:
/var/tmp/expert3d.remove
A log of this installation can be found at:
/var/tmp/expert3d.install.2000.09.27
To configure a Sun Expert3D accelerator, use the fbconfig
utility. See the fbconfig(1m) and SUNWifb_config(1m) manual
pages for more details.
*** IMPORTANT NOTE! ***
This system must be rebooted for the new software to take effect.
Shutdown the system using the shutdown command and then reboot the
system using the ’boot -r’ PROM command at the ’ok’ prompt. See
the shutdown(1M) and boot(1M) manual pages for more details.
# shutdown
ok boot -r
Содержание Sun Expert3D
Страница 6: ...vi Sun Expert3D Graphics Card Installation Guide September 2000 ...
Страница 10: ...x Sun Expert3D Graphics Card Installation Guide September 2000 ...
Страница 12: ...xii Sun Expert3D Graphics Card Installation Guide September 2000 ...
Страница 44: ...28 Sun Expert3D Graphics Card Installation Guide September 2000 ...