**ADIC / Sun Confidential**
Sun_StorEdge_L7_Decision_Tree_Rev01_
14.0 REAR SLOT
This error message indicates a rear slot sensor was not tripped after a tape move to a rear storage slot. A
defective rear slot sensor can cause this error. Troubleshooting should begin with retrying the move
operation to the same rear slot. An obstructed rear slot sensor (dust, lint, etc. blocking the slot sensor) can
also cause this error. Troubleshooting should continue with using compressed air to remove dust/debris
from the slot sensor.
DP1:
Check to see if the error message is still present after retrying the tape move operation.
R1:
Error message is still present.
A1:
Power down the autoloader.
A1:
Remove all tapes from the autoloader.
A1:
Use compressed air to clean all tape slot sensors.
A1:
Replace all tapes.
A1:
Power up the autoloader and retry the autoloader move operation.
DP2:
Check to see if the error message is still present.
R2:
Error message is still present.
A2:
Replace the autoloader.
R2:
Error message no longer present.
A2:
Continue normal autoloader operation.
R1:
Error message no longer present.
A1:
Continue normal autoloader operation.
15.0 FRONT SLOT
This error message indicates a front slot sensor was not tripped after a tape move to a front storage slot. A
defective front slot sensor can cause this error. Troubleshooting should begin with retrying the move
operation to the same front slot. An obstructed front slot sensor (dust, lint, etc. blocking the slot sensor)
can also cause this error. Troubleshooting should continue with using compressed air to remove dust/debris
from the slot sensor.
DP1:
Check to see if the error message is still present after retrying the tape move operation.
R1:
Error message is still present.
A1:
Power down the autoloader.
A1:
Remove all tapes from the autoloader.
A1:
Use compressed air to clean all tape slot sensors.
A1:
Replace all tapes.
A1:
Power up the autoloader and retry the autoloader move operation.
DP2:
Check to see if the error message is still present.
R2:
Error message is still present.
A2:
Replace the autoloader.
R2:
Error message no longer present.
A2:
Continue normal autoloader operation.
R1:
Error message no longer present.
A1:
Continue normal autoloader operation.
