**ADIC / Sun Confidential**
Sun_StorEdge_L7_Decision_Tree_Rev01_
26.0 dRIVE POST
This error message indicates the drive failed to complete its Power On Self Test (POST). A dRIVE POST
error can occur if any of the following errors occur during the StorEdge L7 POST:
Ø
CT FAILED – Cleaning tape failed to clean drive.
Ø
dRIVE BUSY – Drive busy, cannot unload tape.
Ø
dRIVE dOOR – Drive door stepper motor limit.
Ø
dRIVE EJCT – Drive failed to eject medium.
Ø
dRIVE HNdL – Drive ‘Operate Handle’ timeout.
Ø
dRIVE LOAd – Unable to load medium into the drive.
Ø
dRIVE PGRM – Attempt to set drive parameters failed.
Ø
dRIVE UNLd – Drive not logically unloaded.
Troubleshooting should begin with cycling power to the autoloader.
Note:
When powering off the autoloader, the POWER button on the front panel of the autoloader must be
pressed and held for 2 seconds.
DP1:
Check to see if the error message is still present after cycling autoloader power.
R1:
Error message is still present.
A1:
Refer to the errors listed above for specific actions to perform.
R1:
Error message no longer present.
A1:
Continue normal autoloader operation.
27.0 RObOT POST
This error message indicates the robotics failed to complete its Power On Self Test (POST). A RObOT POST
error can occur if any errors other than those listed under dRIVE POST occur during the StorEdge L7 POST.
Troubleshooting should begin with visually inspecting the autoloader to identify any obvious mechanically
stuck components or foreign material that may be present. Mechanically stuck components include items
such as a cartridge stuck in the picker, a rear storage slot, a front storage slot, or a drive. Remove any
foreign material or stuck component that is present.
DP1:
Check the Picker path for obstructions.
R1:
Picker path obstruction not found.
A1:
Cycle power to the autoloader.
DP2:
Check to see if the error message is still present after cycling library power.
R2:
Error message is still present.
A2:
Replace the autoloader.
R2:
Error message no longer present.
A2:
Continue normal autoloader operation.
R1:
Picker path obstruction found.
A1:
Clear obstruction.
