Preface
The
Sun Cluster 3.0-3.1 With Sun StorEdge 6120 Array Manual for Solaris OS
provides
procedures specific to Sun™ StorEdge™ 6120 arrays in dual-controller configurations
and in single–controller configurations that are placed in a Sun™ Cluster
environment.
Use this manual with any version of Sun Cluster 3.0 or 3.1 software on SPARC
®
based
clusters and any supported version of Sun Cluster 3.1 software on x86 based clusters.
Unless otherwise noted, procedures are the same for all supported Sun Cluster
versions. See the
for a list of changes to this manual.
Note –
In this document, the term “x86” refers to the Intel 32-bit family of
microprocessor chips and compatible microprocessor chips made by AMD.
Sun Cluster software runs on two platforms, SPARC and x86. The information in this
document pertains to both platforms unless otherwise specified in a special chapter,
section, note, bulleted item, figure, table, or example.
Who Should Use This Book
This book is for Sun representatives who are performing the initial installation of a
Sun Cluster configuration and for system administrators who are responsible for
maintaining the system.
This document is intended for experienced system administrators with extensive
knowledge of Sun software and hardware. Do not use this document as a planning or
presales guide. You should have already determined your system requirements and
purchased the appropriate equipment and software before reading this document.
5
