10
Sun Blade 8000 Series Site Planning Guide • February 2008
Install a standalone system or a rackmounted system on a level surface. At the base
of the cabinet is an anti-tilt bar. This bar must be extended before you install the
Sun Blade 8000 Series system to prevent the cabinet from moving. For stability, only
one Sun Blade 8000 Series system should be extended from the cabinet at one time.
Always install equipment in the cabinet from the bottom up to help stabilize the
cabinet.
Placement of a Sun Product
Do not block or cover the openings of the Sun Blade 8000 Series system. Never place
a Sun product near a radiator or heat register. Failure to follow these guidelines can
cause overheating and affect the reliability of your Sun product. Air cools the Sun
Blade 8000 Series system from front to back. The front and rear cabinet door
clearances must provide sufficient space for cooling. See
for specific clearance specifications.
Hazardous Conditions Precautions
Because of the inherent nature of the system’s modular design, care must be taken to
ensure that operators are not exposed to the hazardous conditions as defined in
TABLE 3
Hazardous Conditions Restrictions
Hazard
Limit
Voltage
Greater than 60 VDC, 30 VRMS, or 42.4V peak-to-peak
Energy
Greater than 240 VA
Mechanical
Moving parts and sharp edges
