19
Lexmark E238
Lexmark Toner Cartridge Part #’s 23800SW, (Return
Program),
23820SW (Standard)
OEM Toner Stated Yield: 2,000
OEM Drum cartridge 12A8302, Stated drum yield:
30,000
Toner cartridges
: The “Return” toner cartridges
have an ARD on a small board located inside the
right end cap of the cartridge. Like other cartridges
in this series, the board for these cartridges has two
contact pads where the machine makes direct
contact. New replacement chips are available now.
On the Non-“Return” cartridges the chip is also
present, but the killer part is not active. The Standard
cartridges can be re-manufactured as much as you
want, the chip will not interfere
.
In both cases, the
chips use the new “Overdrive code”. Make sure
your supplier is up to date with the proper code.
There are multiple other printer brands that use this
engine. Some manufacturers have universal chips,
some have individual chips. Make sure you have the
correct ones.
E238 Drum units:
With the printer turned on and in
the READY state, open the front cover. Press and
hold the CANCEL button until all the lights begin
flashing up and down. Release the CANCEL button
and close the door.
Lexmark E250/350
Lexmark Toner Cartridge Part #’s E250A11A,
(Return Program),
E250A21A (Standard)
OEM Toner Stated Yield:
OEM Drum cartridge E250X22G, Stated drum yield:
This series was just released as of this writing. No
information is available yet on the chips, or resets if
needed. Check with your supplier for more
information.
Lexmark E450
Lexmark Toner Cartridge Part #’s E450A11A,
(Return Program),
E450H11A (Standard)
OEM Toner Stated Yield:
OEM Drum cartridge E250X22G, Stated drum yield:
This series was just released as of this writing. No
information is available yet on the chips, or resets if
needed. Check with your supplier for more
information.
Lexmark 4500 (E320/322)
Lexmark Cartridge Part # 08A0476/08A0478
(Prebate), 08A0477 (Non Prebate))
OEM Stated Yield: 0476: 3,000, 00478/0477: 6,000
The “Return” cartridges have an ARD on a small
board located inside the right end cap of the
cartridge. Unlike other Lexmark chips, the board for
these cartridges has two contact pads where the
machine makes direct contact. New replacement
chips are available now. On the Non-Prebate
cartridges the chip is also present, but the killer part
is not active. These cartridges can be re-
manufactured as much as you want, the chip will not
interfere.