42
type of replacement cartridge that the machine is
expecting. 001=113R180/181, 005 = 113R287.
If the cartridges your machine needs is not available,
you can change what type of cartridge the machine
will accept by doing the following. Enter the
diagnostics mode as in above. Enter “406 “ and press
Print. Turn off the power and install the correct
cartridge. The machine will now look for that type of
cartridge from now on. Only do this if you are sure
that you will be supplying the cartridges for this
machine. If the customer goes out and purchases the
“correct” cartridge that was made for his machine, it
will no longer work until the above procedure is run
again.
Xerox DC 220
Xerox Cartridge part #
113R120/113R178/113R276
OEM Stated Yield: 20,000
To reset the counter in the DC 220/230/240 OPC
cartridges the connector on the rear of the cartridge
must be replaced. This will clear the J1 or J7 codes.
J1= Toner Out, J7 = Change cartridge
There are many different cartridges that use different
connectors/chips for these machines. A list of them
is as follows:
DC220/230/420 Type A: 113R120, 113R178,
113R276DC220/230/420 Type B: 113R179,
113R275
DC220/230/420 Type C: 113R313
DC332/340 Type A: 113R315, 113R317
DC332/340 Type B: 113R316
Each cartridge type is for a different machine. When
ordering the replacement chip, make sure you know
the correct cartridge part number that your
customer’s machine calls for. The chips are not
interchangeable.
Other cartridges error codes are:
J6: Incorrect cartridge type
J3: Cartridge not seated properly, or not present
Xerox N-24/32/40
OEM Stated Yield: 20-23,000 (Depending on
cartridge)
This engine has more non-interchangeable cartridges
than any engine I have ever seen. All of them use an
"ARD" that is built into the connector. Almost every
type of cartridge has it's own individual ARD. Since
every individual cartridge has it’s own chip, it is
imperative that you have the OEM cartridge part
number when ordering the chips! The reset boards
are now available with the plastic housing so that
soldering the chip in is no longer necessary. There
are also services where you can have the old chip
reset. There are still cartridges that do not have
replacement chips available yet. These are mainly
international, but not all.
Xerox P8E (Samsung FS-5000
Engine)
OEM Stated Yield: 5,000 (Except for Lexmark
13T0101: 6,000)
There are 3 main versions of this cartridge so far.
The Xerox Docuprint P8e 113R296/100R364,
WorkCentre 385 113R 296, and the Lexmark Optra
E310/312 NOTE: Lexmark has replaced the
12A2202 (5k) cartridge with the 13T0101 (6k)
cartridge. The new cartridge works in both
machines.
When recycling these cartridges the fuse must be
replaced in the Xerox cartridges. The Lexmark
cartridges have a plastic dummy fuse in it. There has
been some conflicting information on if the fuse
should be replaced or not, the following should help
to clear it up. If the machine says toner low and the
