PG 7
9.
Place the Cross Support (
item I
) to the FRONT side of the Support Tubes near the top
(see figure 11)
and secure using (2)
65mm bolts with locknuts.
10.
Place the Middle Seat Support (
Item J
) to the center hole in the Foot Platform assembly and secure using (1) 90mm bolt with
locknut.
See figure 12.
11.
Attach the opposite end of the Middle Seat Support (
item J
) to the BOTTOM side of the Cross Support (
item I
) and secure
using (1) 65mm bolt with lock nut.
See figure 13.
I
11
J
12
13
I
J
SEAT ASSEMBLY
14
R
MOUNTING
HOLE ON NON-
BENT END
12.
Place one of the Seat Bases (
item R
) to the right or left side of the Seat Frame as shown in
figure 14
.
Secure using (1) 65mm
bolt with a Nylon Washer - Wide between the Seat Base and Seat Frame.
Note: The Seat Base has mounting holes on the non-bent end of the seat tubes.
Part Stack: Seat Frame, Nylon Washer - Wide, Seat Base, Locknut.
Repeat for the other Seat Base on the opposite side.
13.
Once both Seat Bases are attached to the outside Seat Braces, insert (1) 90mm bolt through the INSIDE hole on one Seat
Base, through the punched hole in the Middle Seat Support and through the other Seat Base. Use a Nylon Washer - Wide
between the Seat Bases and Middle Seat Support.
See figure 13 and 15.
Note: The welded U-Clip on the Middle Seat Support is used for the Seat Back assemblies.
Part Stack: Seat Base, Nylon Washer - Wide, Middle Seat Support, Nylon Washer - Wide, Seat Base, Locknut.
15
