14.
Place one of the Seat Backs (
item S
) to the right or left side of the Seat Frame as shown in
figure 16
.
Secure using (1) 65mm
bolt with a Nylon Washer - Wide between the Seat Back and Seat Frame.
Note: The Seat Back has mounting holes on the bent end of the seat tubes.
Part Stack: Seat Frame, Nylon Washer - Wide, Seat Back, Locknut.
Repeat for the other Seat Back on the opposite side.
15.
Once both Seat Backs are attached to the outside Seat Braces, insert (1) 90mm bolt through the INSIDE hole on one Seat
Back, through the welded u-bracket on the Middle Seat Support and through the other Seat Back. Use a Nylon Washer - Wide
between the Seat Backs and the Middle Seat Support bracket.
See figure 17.
Part Stack: Seat Back, Nylon Washer - Wide, Middle Seat Support U-Bracket, Nylon Washer - Wide, Seat Back, Locknut.
16.
Your finished Seat Bases and Seat Backs should look like
figure 18 and 19
.
17.
Slide the swaged end of the Gun Rest Rail 1 (
item L
) into the Gun Rest Rail 2 (
item M
) and secure together using (1) 40mm
bolt and locknut.
See figure 20
.
18.
Place the Gun Rest onto the outside of the Seat Frame Assembly. Insert (1) 70mm bolt through Gun Rest in the hole closest
to the end of the Gun Rest Assembly. Use a Nylon Washer - Narrow between the Gun Rest and the Seat Frame.
See figure 21.
Part Stack: Gun Rest, Nylon Washer - Narrow, Seat Frame, V-Plate Frame, Locknut
Secure locknuts. Repeat for the other side.
S
S
WELDED
BRACKET
S
16
17
PG 8
18
19
SWAGED END
L
M
20
21
HOLE CLOSEST
TO THE END
GUN REST - STOP
BOLT - ALL THREAD
