Sumitomo Cyclo HBB, Руководство по эксплуатации и техническому обслуживанию

Страница: 47 / 50

Cyclo® HBB
46
Operation & Maintenance Manual
Cyclo® HBB
Troubleshooting
Problem with the Motor Possible Causes Suggested Remedy
Load is
disconnected
but motor does
not rotate
Makes a
“groaning” sound
Faulty switch contact Adjust the contact
Blown fuse Replace fuse
One phase wire of the power supply
open
Replace
Stator coil open
Repair by rewinding or replacing the stator assembly
Stator and rotor touching due to bearing
housing wear
Replace the bearing and bracket.
Rotates in either
direction when turned
by hand
Three-phase is operating as singlephase Check the power source with a voltmeter.
Doesn’t make any
noise
Stator coil open Repair by rewinding or replacing stator assembly
External power failure Contact the local power company
Open connection wire Check the source wiring.
Faulty switch contact
Faulty starter contact
Adjust the contacts
Rotates with
the load
disconnected
but:
Rotates in the wrong
direction
Connection error Change any two of the three-phase source connections
Fuse blows Shorted lead wire Replace
Speed does not increase Faulty starter contact Adjust
“Groans”
Excessive Current / Overheating due to
rotor and stator touching
Repair by rewinding or replacing stator assembly
Excessive current due to one phase of
stator coil shorted
Replace the stator winding
Makes a highpitched
“metallic” noise
Faulty bearing Replace the bearing
Rotates when
the load is
disconnected
but when the
load is
connected:
Switch overheats
Insufficient switch capacity Replace with switch having the rated capacity
Overload Decrease load to the rated level
Fuse blows Insufficient fuse capacity Replace with fuse having the rated capacity
Overheats
Overload Decrease load to rated value
Voltage drop Consult with local power company
Speed suddenly drops
Voltage drop Consult with local power company
Overload Decrease load to rated value
Stops Bearing damaged by overheating Replace the bearings