Sumitomo Cyclo HBB, Руководство по эксплуатации и техническому обслуживанию

Страница: 15 / 50

14
Operation & Maintenance Manual
Cyclo® HBB
Cyclo® HBB
3
Align the driven shaft with the reducer/gearmotor bore and carefully slide unit onto
the driven shaft
• If the fit is tight, strike on the keyed hollow bore with a mallet to assist in the assembly.
If using a mallet during installation, strike
only
against the unit’s steel keyed
hollow bore. Do not strike the reducer housing or oil seal, damage to the
bearings, the housing, and/or the seals may occur
Note:
If the fit is tight, you may use a jig such as the one shown here to ease
assembly Sumitomo Drive Technologies does not supply a mounting
jig This information is provided for reference only
4
Once driven shaft has been completely inserted into the unit’s keyed hollow bore,
secure the shaft in place using a keeper plate as shown in this example.
Do not operate unit until the torque arm has been attached
Refer to the
Torque Arm Installation section in this manual for instructions
Installation onto Driven Shaft
Keyed Hollow Bore Installation
Spacer
Retaining Ring
Ball Bearing
Threaded Rod