SULPICE TV IPTV32SULP3FHD110DW, Руководство по эксплуатации

Страница: 51 / 68

English - 16 -
STANDBY
"Switch box to Standby
mode.
( Attention: Television
cannot be opened with
standby command.
You should open it with
remote control.
If you use STANDBY
command, you will
need to establish the
connection again.
Tv state :HARD-
STANDBY )"
no parameter
"#*enterLowPowerMode() returns
successfully.
or
#*enterLowPowerMode() returns
unsuccessfully!
or
#*enterStandbyMode() returns
successfully.
or
#*enterStandbyMode() returns
unsuccessfully!
"
MENUTIMEOUT Set menu time out mode. integer n (n = 0 , n = 15, n =
30, n = 60)
"#*set menu timeout mode to OFF
or
#*set menu timeout mode to 60
or
#*Invalid menu timeout mode
"
GETMODELNO Get model no. no parameter #*Model no: ...
GETSERIALNO Get serial no. no parameter #*Serial no: ...
GETLED Get led on/off state. no parameter
"#*LED is on
#*LED is off"
GETRC
Get remote control
commands enabled
status
no parameter
"#*remote control commands are
on
#*remote control commands are
off"
USBOPERATIONS Perform USB Operations no parameter
You may observe prints Bank 0,
Bank 1 etc. Be sure or observe
debug print outs: "MFC ISP: done"
will be writen... This may take over
10 minutes.
GETMENUTIMEOUT Get menu time out mode no parameter
"#*menu timeout mode is OFF
#*menu timeout mode is n
#*can not get menu timeout mode
Note: Above n is one of (15, 30,
60)"
GETTVLIFETIME
Prints TV life time in
minutes.
no parameter #*Monitor Life Time: n
SETPOWERONDELAY
Set poweron delay level
integer n (0<=n<=20, delay
is calculated as 100ms*n)
"#*Poweron delay set to ... Ms
#*NACK"
GETPOWERONDELAY Get poweron delay level no parameter #*The power on delay is … ms
SIGNAGERESET
Set all items in the
signage settings menu to
their default values.
no parameter
#*All signage settings set to default
values
SELECTSOURCE
Select source.
(0=TV, other source
indexes(some of them
are not enabled))
integer n (5=FAV,
7=HDMI1, 8=HDMI2,
11=YPbPr, 12=Vga,
18=DVI , 19=DP ,
20=OPS)
" #*select TV source
or
#*select External source …"
KEY standby
Switch box to Standby
mode. ( For quick
standby)
no parameter standby key send to Eclipse