f
it
protective
guard
The bolts and the grooves must align.
a
djuStment
of
Safety
guard
Bring the safety guard into the desired working position.
For fastening the screw must be tightened down.
To release, turn screw back approx. ½ rotation.
Safe operation is guaranteed only with tightened
screw.
r
emoval
of
Safety
guard
If necessary, release screw with Allen key. Bring bolt and
groove into alignment and remove the safety guard.
c
leaning
of
locking
mechaniSm
Remove safety guard as mentioned above.
Remove clamping nut and backing flange.
Loosen and remove the three clamping screws.
Carefully remove the spring washer with the three balls,
the drive plate and the washer. Thoroughly clean all parts.
Replace defective parts. Lubricate spring disc ball traveler
with a little commercially available multi-purpose grease.
Refit all parts in reverse sequence, making sure that the
drive plate and spring washers are correctly aligned
(grooves).
Hex socket head screws M3x6 are used to tension
the locking mechanism.
3.1.2 A
dditionAl
hAndle
The additional handle must be screwed in at the left or
right, or in the gearbox head at the top.
Befor fitting, blow out the thread in the gearbox
head.
17
P
ortugúes
Español
Italiano
English
F
rançais
Deutsch
English
