SUEX XJ37, Инструкция по эксплуатации и предупреждения

Страница: 28 / 97

TO ENSURE YOUR USER INFORMATION IS UP TO DATE PLEASE DOWNLOAD THE LATEST VERSION OF THIS MANUAL FROM WWW.SUEX
Page 28 of 48
26 M
AINTENANCE
Lubrication of head cap O-ring case
Open the ADV, gently remove the lock O-ring (19) (see fig. 6) being careful not to
scratch the O-ring support surfaces, and clean the seating thoroughly (only by means of
a clean brush or soft cloth). Do not use any type of solvent or alcohol. Apply silicone oil
to the O-ring and return it to its place. Do not use any other type of oil!!! We recommend
the aerosol spray type which is usually used for diving equipment. Occasionally,
lubricate the lock knob screw with normal mineral grease. Never lubricate trigger or
magnetic piston movement. They would fill of sand and dirt. Do not lubricate electrical
contacts!
Closing knob gasket maintenance
Whenever the closing knob (9) (see fig. 1) comes into contact with sand, rinse with
running water before rotating it. About every 50 uses, remove it, using pliers, clean the
gaskets and lubricate with silicon oil, If you are not familiar with this operation, contact
an authorized service centre.
Aluminium body maintenance
The aluminium body was protection with a special hard anodized so that it is immune to
normal saline corrosion. When collisions or incorrect use ruin this protection, the body
material, aluminium, comes into contact with water and this could be a source of
corrosion, especially in salt water. If the protection is damaged, be careful to rinse the
ADV, leaving it in fresh water for at least 15 minutes.
NOTE: leaving the ADV exposed to the sun for long periods of time could damage
the colour creating lighter or grey areas. This situation does not compromise the
oxidation protection since it is only an aesthetic effect. Some longitudinal lines
observable on the aluminium body are perfectly normal, they depends from the
material and are not mark of defect or material stress. Please remember that
surface deterioration is considered normal wear and is not covered by the
warranty.
Supplementary maintenance
Every hundred hours of use or at least every two years, we recommend you overhaul
the ADV checking hydraulic seals and electrical circuits.
SUEX S.r.l. fully overhauls your ADV with shipping throughout the world.
NOTE: using spray lubricants, it is important to air the inside of the
ADV. In this way the propelling gas go away, for the most part are
inflammable!