Subzero CRC 1200, Руководство пользователя

Страница: 2 / 11

DESCRIPTION PARAMETER
Introduction
Pg.
No.
Index Index
01 CRC1200
DESCRIPTION PARAMETER
Pg.
No.
02 CRC1200
Get to Know Your Controller
Parameter List
4
5
To set the cut-out point of the controller.
To set the Maximum System Cooling
temperature.
SET POINT
MAX SET POINT
To set the Minimum Cooling
Temperature. MIN SET POINT
To set the differential for Compressor
restart. DIFFERENTIAL
To set Quick Freeze Set Point. QUICK FREEZE SP
To set Quick Freeze Duration.
To set Room Probe 1 calibration.
QUICK FREEZE DUR
ROOM PROBE CAL
To set time delay between compressors
relay restart time. COMP TIME DELAY
To set drip time for defrost water. DRIP TIME DUR
To set Post Drip Timings. POST DRIP TIMING
To Set Condensor On Delay Timings. CONDENSOR ON DLY
To set Evaporator Fan Stop
Temperature. EVAP FAN STOP TC
To set Evaporator Restart Time Delay. EVAP TIME DELAY
COMP ON PRB.FAIL To set compressor function during
Room probe failure.
5
6
6
8
9
10
7
7
7
8
9
9
9
10
To set Evap Fan operation when
compressor is off. EVAP Wn COMP OFF
10
To set Evaporator Differential. EVAP DIFFERENTIAL
To set coil probe calibration. COIL PROBE CAL.
11
10
Key Introduction 5
Wiring Diagram
Caution & Warranty
To set Evap. Fan status during defrost. EVAP At DEFROST
To set type of defrost.
DEFROST TYPE
To set type of computation for defrost
time. DEFROST COMPUTING
To Set Defrost frequency. DEFROSTFREQUENCY
To set Maximum Defrost duration.
DEFROST DURATION
To set final defrost temperature.
(Coil probe).
DEFROST STOP
TEMPERATURE
To activate power ON Defrost. POWER ON DEFROST
To activate Solenoid Valve Relay. PUMP DOWN
To activate Keypad Lock. KEYPAD LOCK
To revert to Factory Parameters. FACTORY RESET
To Save programming. SAVE PROGRAMMING
EVAP At DOOR Open To set Evap. Fan status during Door
open condition
DEFROST DURATION IN
COIL PRB. FAIL To set Defrost duration IN Coil probe
Failure.
12
13
13
14
14
14
14
11
11
11
12
12
13
Technical Data
Technical Data
15
16
18
17
3
Main Programming Mode 5