Subaru S209 2019, Руководство по обслуживанию

Страница: 245 / 297

EI-57
Side Garnish & Side Spoiler
EXTERIOR/INTERIOR TRIM
CAUTION:
Attach the pattern paper along the arch section.
(8) Make mark-off lines for drilling holes (c) at 3 locations according to the pattern papers (a) and (b).
(9) Remove the pattern paper.
(10) Make a pilot hole of 3 mm (0.12 in) diameter at the mark-off line position (f) using a drill (e), and then
make a pilot hole of 6 mm (0.24 in) diameter. Finally, make a hole of 9.5 mm (0.37 in) diameter.
CAUTION:
• Be sure to make a hole of a specified diameter. The rear quarter garnish may not be installed if the
hole diameter is large.
(a) Pattern paper RQ GARN (c) Masking tape (d) Alignment position for radius curve
end
(b) Pattern paper RQ GARN
(a) Pattern paper RQ GARN (b) Pattern paper RQ GARN (c) Mark-off line position
AA-10150
(c)
(a)
(c)
(d)
(b)
(c)
(c)
(c)
(c)
AA-10151
(a)
(b)
(c)
(c)
(c)