Subaru LEGACY, Руководство пользователя

Страница: 144 / 454

Black plate (147,1)
北 米
Model "A2470BE-A" EDITED: 2010/ 3/ 24
!
Gear position indicator setting (MT
models)
The gear position indicator light can be
activated or deactivated by performing the
following procedure.
1. Turn the ignition switch to the
“
LOCK
”
position.
2. Press the trip knob to show
“ ”
or
“ ”
on the trip meter display.
The display can be switched as shown in
the following illustration by pressing the
trip knob.
*
1
:
“ ”
or
“ ”
and
“ ”
or
“ ”
cannot
be displayed when the ignition switch is
in the
“
ON
”
position.
*
2
: MT models only
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
.
The initial setting for your vehicle of
the gear position indicator has been set
for activation
“ ”
at the time of
shipment from the factory.
.
It is not possible to change the
setting of the gear position indicator
when the ignition switch is in the
“
ON
”
position. Change the setting when the
ignition switch is in the
“
LOCK
”
or
“
Acc
”
position.
&
Turn signal indicator
lights
These lights show the operation of the turn
signal or lane change signal.
If the indicator lights do not blink or blink
rapidly, the turn signal bulb may be burned
out. Replace the bulb as soon as possible.
Refer to
“
Replacing bulbs
” F
11-49.
&
High beam indicator
light
This light shows that the headlights are in
the high beam mode.
This indicator light also illuminates when
the headlight flasher is operated.
&
Cruise control indica-
tor light
The cruise control indicator light illumi-
nates when the ignition switch is turned to
the
“
ON
”
position and turns off after
approximately 3 seconds.
This light illuminates when the
“
CRUISE
”
main switch is pressed.
NOTE
.
If you press the main switch button
while turning the ignition switch
“
ON
”
,
the cruise control function is deacti-
vated and the
“
CRUISE
”
indicator light
flashes. To reactivate the cruise control
function, turn the ignition switch back
to the
“
Acc
”
or
“
LOCK
”
position, and
then turn it again to the
“
ON
”
position.
.
If this indicator light and the CHECK
ENGINE warning light/malfunction in-
dicator lamp flash simultaneously dur-
ing driving, have the vehicle checked
by your nearest SUBARU dealer.
&
Cruise control set in-
dicator light
The cruise control set indicator light
illuminates when the ignition switch is
turned to the
“
ON
”
position and turns off
after approximately 3 seconds.
Instruments and controls
3-23
–
CONTINUED
–
3