Subaru 2004 Forester, Руководство по обслуживанию

Страница: 122 / 622

AB-26
AIRBAG SYSTEM
Disposal of Airbag Module (Deploying After Removal from Vehicle)
12.Disposal of Airbag Module
(Deploying After Removal
from Vehicle)
A: OPERATION
CAUTION:
• Do not discard an undeployed airbag module
because it may cause serious personal injury
when accidentally deployed.
• As a rule, the airbag module should be de-
ployed while still installed in the vehicle. Do not
remove the airbag modules unless necessary.
• Deployment of the airbag module should be
done on a flat place free from any possible dan-
ger. Avoid deploying outdoors during rainy or
windy weather.
• Do not damage the airbag module or drop it.
• Deploying the airbag module causes a high
explosive noise, be sure to warn people in the
area, and do not allow anyone within a 5 m (16
ft) radius of the disposal site.
• Some smoke will be emitted from deployment
of the airbag module. Therefore, it must be de-
ployed in a well ventilated place with no smoke
detector nearby.
• Wear protective gloves, safety goggles and
earplugs during this operation. Wash your
hands afterwards.
• After deployment, the airbag module will be
especially hot, leave it unattended for 40 min-
utes, and then discard it.
• Do not let water get on the deployed airbag
module.
• Wrap the deployed airbag module in an air-
tight vinyl bag, and discard it.
• If circumstances do not permit the airbag
module deployment, contact the SUBARU deal-
er.
1. DRIVER’S AIRBAG MODULE
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and
wait for at least 20 seconds before starting work.
3) Remove the driver’s airbag module. <Ref. to AB-
14, Driver’s Airbag Module.>
4) Install the removed bolts to airbag module.
5) Bundle three automotive wire harnesses [each
with a sectional area of 1.25 mm
2
(0.00194 sq in) or
more], and bind them twofold around airbag mod-
ule stay.
6) Short the terminal to alligator clip furnished as
deployment tool (A).
7) Connect the deployment tool and deployment
adapter D (B).
CAUTION:
The deployment tool should be kept shorted
terminals until just before deployment of airbag
module.
8) Connect the deployment adapter D connector to
airbag module.
(A) Deployment tool:
(Tool number 98299PA030)
(B) Deployment adapter D:
(Tool number 98299SA010)
AB-00780
AB-00048
SB-00021
(A)
(B)