Subaru 2004 Forester, Руководство по обслуживанию

Страница: 64 / 622

AC-10
HVAC SYSTEM (AUTO A/C)(DIAGNOSTIC)
Diagnostic Chart for Self-Diagnosis
Step Check Yes No
1 SELECT CONTROL PANEL TO SELF-DIAG-
NOSIS MODE.
1) Turn the ignition switch to OFF.
2) Start the engine while pressing defroster
switch and A/C switch.
NOTE:
Self-diagnosis can also be performed with the
ignition switch ON, but start the engine be-
cause telling the magnet clutch operation is dif-
ficult.
3) The LED in A/C control panel blinks.
Does the self-diagnosis mode
operate? Go to step 2. <Ref. to AC-12, A/
C OR SELF-DIAG-
NOSIS SYS-
TEMS DO NOT
OPERATE, Diag-
nostics for A/C
System Malfunc-
tion.>
2 CHECK LED ILLUMINATION.
Make sure that three LED blink in turn on A/C
control panel (5 patterns are repeated 2 times).
Do all LED blink? Go to step 3. Go to step 5.
3 CHECK SENSORS MALFUNCTION.
1) After completing the LED check or when
AUTO switch is pressed, the A/C switch LED
illuminates, and then the sensor check is
started.
2) Check the input signal of each sensor in
turn. If there are any trouble for each sensor,
DEF, MODE and fan speed LEDs are blinked.
Also check for each sensor is possible respec-
tively every time AUTO switch is pressed. (At
this time, the AUTO switch LED illuminates.)
3) If there is no trouble, DEF, MODE and fan
speed LEDs are turned off.
NOTE:
Rear window defogger LED illuminates in case
of stored malfunction but does not illuminate in
case of present malfunction.
Does each DEF, MODE and
fan speed LED turn off? Go to step 4. Confirm the com-
bination of illumi-
nating LEDs by
using Sensor
Check Table, and
identify the mal-
functioning sensor
before repairing.
<Ref. to AC-11,
SENSOR CHECK
TABLE, OPERA-
TION, Diagnostic
Chart for Self-
Diagnosis.>
4 CHECK OPERATION OF EACH ACTUATOR,
COMPRESSOR AND FAN MOTOR.
1) Press the FRESH/RECIRC switch
(FRESH/RECIRC switch LED illuminates at
this time.).
2) Refer to OPERATING MODE TABLE to
check the operation of each actuator, compres-
sor and fan motor. <Ref. to AC-11, OPERAT-
ING MODE TABLE, OPERATION, Diagnostic
Chart for Self-Diagnosis.>
Also check for each step is possible respec-
tively every time AUTO switch pressed. (At this
time, the AUTO switch LED illuminates.)
Does each actuator, compres-
sor and fan motor operate
according to operating mode
table? Press the OFF
switch or turn the
ignition switch to
OFF and finish the
self-diagnosis
mode. Refer to each
diagnostics chart
for actuator, com-
pressor and fan
motor, and repair
the malfunctioning
part as necessary.
<Ref. to AC-12,
Diagnostics for A/
C System Mal-
function.> <Ref. to
AC-21, Diagnostic
Procedure for
Actuators.>
5 CHECK POOR CONTACT.
Check the auto A/C control module connector
for poor contact.
Is there a poor contact in con-
nector? Replace the auto
A/C control mod-
ule. Repair the con-
nector.