Get to Know Your Controller
Parameter List
4
5
To set the cut-out point of the controller.
How to set other parameter.
SET POINT
To set Minimum allowable low Temperature
limit.
LOW SET ALARM
P3 Parameter
To set time delay between comp. relay restart
time.
ROOM PROBE CALIB
P5 Parameter
5
6
5
7
Items Included
4
Key Introduction
5
Index
DESCRIPTION
PARAMETER
Pg.
No.
01
CRC1100A
To set Maximum allowable High Temperature
limit.
HIGH SET ALARM
P2 Parameter
5
6
To set comp. Differential (Hysterisis).
ROOM PROBE DIFF.
P4 Parameter
To set room Probe offset calibration.
Operation
3
COMP. TIME DELAY
P6 Parameter
To set drip time for defrost water to drain out.
To set comp. relay status on room probe
failure
7
7
DRIP TIME
P7 Parameter
COMP IN PRB FAIL
P8 Parameter
Cyclic ON time.
7
CYC. ON TIME
ON Time Parameter
Cyclic OFF time.
8
CYC. OFF TIME
OFF Time Parameter
To set door open alarm delay.
8
DOOR ALARM DELEY
P9 Parameter
Evap. Fan stop coil temp.
8
FAN STOP TEMP.
L1 Parameter
To set time delay between Evap. fan relay
restart time.
8
FAN TIME DELEY
L2 Parameter
Evap. Fan operation when compressor is off.
8
FAN IF COMP OFF
L3 Parameter
Evap. fan differential (hysteresis).
9
COIL PROBE DIFF.
L4 Parameter
To set coil probe offset calibration (evap. fan
coil probe).
9
COIL PROBE CALIB
L5 Parameter
Evap. fan status during defrost.
9
FAN WHEN DEFROST
L6 Parameter
Index
DESCRIPTION
PARAMETER
Pg.
No.
CRC1100A
Evap. fan status on door open.
FAN WITH DOOR
L7 Parameter
9
Alarm to check Heater function.
Power on time delay for Alarm(HT/LT).
POWER ON ALM DLY
AL Parameter
To end programming.
2
End Parameter
END OF PROG.
Operating Messages and Icon Status.
6
To set Condenser delay to start before comp.
COND START DELAY
d1 Parameter
10
To set Condenser relay status during Hot gas
defrost.
COND WHEN DEF.
d2 Parameter
10
QUICK FREEZE SP
CS Parameter
To set quick freeze set point.
10
To set Quick Freeze time duration.
QUICK FREEZE DUR
Ct Parameter
10
To set / activate power up defrost cycle.
POWER ON DEFROST
E0 Parameter
10
To set type of defrost.
TYPE OF DEFROST
E1 Parameter
11
To set type of computation for defrost
frequency.
DEF. TIME CALC.
E2 Parameter
11
To set
Defrost frequency.
DEF. FREQUENCY
E3 Parameter
11
To set
Maximum defrost duration
MAX. DEF. DURATION
E4 Parameter
11-12
Defrost stop temperature (Evap. coil probe).
MAX. DEF. TEMP
E5 Parameter
12
HEATER CHK. FUNC
E6 Parameter
12
To set display during defrost.
DISP. DURING DEF
E7 Parameter
12
To set maximum defrost duration on coil probe
fail.
PROB. FAIL DEF. DUR
E8 Parameter
12
13
To lock keypad.
LOCK KEYPAD
LP parameter
13
Revert to factory set parameters.
RESET PARAMETERS
FS Parameter
13
13
13-14
Technical Data
Panel Cutout Dimensions
Wiring Diagram
14
15-16
17
