DESCRIPTION
PARAMETER
Introduction
Pg.
No.
Index
Index
01
DESCRIPTION
PARAMETER
Pg.
No.
02
Get to Know Your Controller
Parameter List
4
5
To set the cut-out point of the controller.
To set maximum allowable high temperature
limit.
SET POINT
P2
To set the Minimum Cooling Temperature.
P3
To set the differential for compressor restart.
P4
To set probe calibration.
P5
To set time delay between relay restart time.
To set duration of defrost.
P6
P7
To set defrost frequency.
P8
To set power on defrost delay.
P9
To enable or disable Buzzer.
BUZ
To set under voltage limit.
UV
To set over voltage limit
OV
To set voltage differential.
V0
AL
Power on time delay for alarm.
5
6
6
8
8
10
7
7
7
8
9
9
9
10
To set time delay for voltage sensing.
V1
10
To set Over current limit.
OL
11
To set Under current limit.
UL
10-11
Key Introduction
5
To set Current sensing delay.
C2
11
D0
To enable or Disable HP sensing.
12
3
Main Programming Mode
5
Suggested wiring diagram for CRC-1001-C
To enable or disable LP sensing.
D1
To set fault sensing logic.
D2
To set LP sensing delay.
D3
To set reset mode for HP fault.
D4
To set Compressor Relay
status on Probe Failure.
E1
To set Evap fan status when
compressor is OFF.
E2
To set EVAP Fan operation at door open.
E4
End of programming.
EP
Technical Data
Suggested wiring diagram for CRC-1001
E3
To set Crankcase Heater operation
when compressor is OFF.
12
14
14
14
17
18
19
12
13
13
13
20
To set Display at defrosting.
E7
14
To set time delay to switch off the light .
LD
15
To change password.
PW
15
To set Unit ID. (For CRC-1001-C only)
Unit ID
16
Factory set parameter.
FS
15
Compressor run Hours.
CRH
15
Clear Compressor Run Hours.
CCRH
16
To activate Keypad Lock.
KEYPAD LOCK
16
Caution & Warranty
21
To enable/disable Power Switch.
PO
17
