13
INPUT CHANNELS
MIC
The MIC (microphone/line input) input channel contains four individual modules: Preamp,
EQ, Dynamics and Bus Send (which incorporates Aux and Effects send). Touching a module
tab will bring up a sub-page with further options.
①
Preamp
Shows the status of Phase Reverse and Input Delay Time
②
EQ
Shows a parametric EQ graph representing the EQ and HPF (High Pass Filter) settings.
③
Dynamics
Shows a gate and compressor graph.
④
Bus Send
Shows send status: the busses being sent to along with its level and Pan value.
MIC PREAMP SUB-PAGE (Touch Tab to Open)
①
Change Input
Touch the arrow-buttons to select the previous or next input.
②
Listen
Touch the
Listen
button to mute all other input and output channels, and to route the channel
output to the Monitor/Headphone output. If another channel is already in Listen mode, you
will hear a mix of both channels.
③
Phase Reverse
Touch to invert phase (button turns green, label changes to “On”). Touch again for normal
phase (button goes dark, label changes to “Off”). Default is normal phase.
④
Input Delay
Touch to enable the delay, default is disabled button turns green, label changes to “On”).
Touch again to disable the delay, (button goes dark, label changes to “Off”).
Adjust the delay time using the soft-encoder on the touch screen. The delay can be adjusted
from 0ms to 200ms. Default is 0ms.
1
2
3
4
1
2
3
4
