6
pict.3
WARNING
!
IP RATE
The declared IP rate of the CityColor comes supported at these conditions:
• the installation of the fixture on a wide and stable surface
• the air cooling input and output are located on the base of the side-shell,
i
t is not possible to install the fixture outdoor with the ballast upwards
• you must use the filter supplied with the basic kit for the IP RATE 54
The CityColor has a IP rate 44 without filters installed and an IP RATE 54 with filters installed.
You must use the filters in critical working conditions and, normally, when the fixture works outdoor.
You must remove the filters when the ambient temperature is over 35°C.
You must regularly clean the filters to allow the correct cooling of the fixture.
You must remove the two side protective shells. The
two filters must be assembled on the bulkheads at the
bottom of the side brackets.
Pay attention to the installation: dust proof filters
must stick correctly to prevent the entrance of the
dust. You must control that the two filters comple-
tely cover the overall of the air entrance.
INSTALLATION OF THE DUST PROOF FILTERS
WARNING
!
You must operate with power supply disconnected from the fixture
