5
C
D
E
C
INSTALLATION OF THE DISCHARGE LAMP
(art. 0002 - 0003)
(see pic.2)
1) Disconnect power before lamp’ s replacement. Wear gloves and goggles.
2) Remove completely the pommels (A) on the base of the head
3) Open the base of the lamp room (G)
4) Remove the two lateral reflectors (C)
5) Lift up the two lampholder (D)
6) Install the new lamp. Taking care that protuberance of the bulb is set towards the reflector
Do not touch the quarz bulb with fingers. If this happenes, clean the bulb before use with dry cloth and alcohol.
7) Put down the two upper lampholders (D)
8) Connect the cables (E) to the two ends of the lamp or connect the two cables of the lamp to the two red insulators on the rear
panel of the head.
9) Put in again the two lateral plane reflectors.
10) Close the rear panel and install again the two pommels (A) and hold them tightly.
In case of replacement of the lamp or maintenance, do not open
the fixture unless 5 minutes have passed from the switching off.
This operation has to be done when the apparatus is disconnected
from the mains supply
WARNING
!
pict.2
A
G
