- 21 -
d) The pump will continue to run until the system set pressure is reached; once this
pressure is reached the pump(s) will slow and stop.
e) If the pumps have not primed correctly the pressure will not increase, repeat the
priming procedure detailed above.
6.17
Stopping:
a) Press the
button, the pump(s) will stop. OFF will be displayed on the screen.
b) To re-start press
button.
6.18
Setting system set pressure (UP05):
a) Press to access menu.
b) Using and
find menu UP, press
to enter.
c) Using and
find parameter UP05, press
to enter.
d) Using and
adjust the set pressure, press
to enter. During this process
the icon will be flashing at the top of the screen.
Warning - DO NOT set
pressure outside the performance of the pump.
e) To exit press
until the initial screen is seen.
f) The icon will disappear from the top of the screen.
See 7.13 for re-setting pressure vessel.
6.19
For Further Technical Support:
Phone PumpAssist on +44 (0) 800 31 969 80.
Our staff are trained to help and advise you over the phone.
