6205-001-700 Rev-A
2008/01
www.stryker.com
7
Troubleshooting Guide*
PROBLEM
CAUSE
ACTION
Handpiece does not run or
turns at a reduced speed.
Battery pack is discharged.
Recharge the battery pack in Stryker battery
charger.
Battery pack is expended.
Replace the battery pack.
f/R/Safe control is in the safe position.
Slide f/R/Safe control to the forward or
forward/reverse position.
Drivetrain is malfunctioning.
Return the handpiece for repair.
Motor runs but cutting acces-
sory does not move.
Drivetrain is malfunctioning.
Return the handpiece for repair.
Attachment is not fully seated.
Remove and insert the attachment. ensure
the attachment is fully seated.
Shifter knob is positioned between the DRILL
and ReAM selections.
Position shifter knob to either the DRILL or
ReAM position.
Battery pack becomes unusu-
ally hot during use.
Circuitry is malfunctioning.
Check the battery pack on the charger.
Replace the battery pack if required. See the
instructions supplied with the battery charger.
Attachment will not fit into the
handpiece.
Debris is on the attachment or inside the front
end of the handpiece.
Clean the attachment and/or handpiece with
a small brush with stiff, non-metallic bristles.
Attachment is damaged.
Return the attachment for repair.
Handpiece is damaged.
Return the handpiece for repair.
Attachment and/or cutting ac-
cessory wobbles in handpiece.
Cutting accessory or wire/pin is bent, extends
too far from the distal end of attachment, is
the wrong size, or is not properly centered in
the attachment.
Reinsert the cutting accessory, wire or pin.
If wobble persists, return the handpiece and
attachment for repair.
A reamer is installed and the handpiece is in
the DRILL mode.
ALWAYS operate reamers in the ReAM mode.
*DO NOT service this equipment. If you require service, contact your Stryker sales representative or call Stryker customer service
at 1-800-25-210. Outside the US, contact your nearest Stryker subsidiary.
