Stryker Prime TC, Руководство по обслуживанию

Страница: 28 / 64

P Prro occe ed du urre e::
1. Using a 3/16” hex wrench, remove the socket head cap screw (A) from the center of the IV pole topper (B). Save the
screw (Figure 15).
A
B
Torque item A
to 25 ± 5 in-lb
F Fiig gu urre e 1 15 5 –– IIV V p po olle e tto op pp pe err rre ep plla acce em me en ntt
2. Tap and push upward on the IV pole topper to remove the topper. Discard the IV pole topper.
3. Position the supplied IV pole topper on the top of the IV pole and use the palm of your hand to tap the topper until the
topper is seated on the IV pole.
4. Using a 3/16” hex wrench, install the socket head cap screw (A) (removed in step 1) to secure the IV pole topper to the
IV pole. Using a 3/8” drive torque wrench, torque the screw to 25 ± 5 in-lb.
5. Verify proper operation before you return the product to service.
L La ap p b be elltt a asssse em mb bllyy iin nsstta alllla attiio on n
N No otte e -- This assembly is available for all products manufactured after August 2013 (see “Serial number location” in your
Operations Manual).
T To oo ollss rre eq qu uiirre ed d::
• 3/16” hex wrench
• 3/16” hex bit
• 3/8” drive torque wrench (in-lb)
P Prro occe ed du urre e::
N No otte e -- The long strap is attached to the right side of the chair. The short strap is attached to the left side of the chair.
1. Apply the brake. Push on the product to make sure that the brake is working.
2. Attach the long strap to the right side of the chair. Attach the short strap to the left side of the chair.
3. Fit the two tabs (A) on the bracket (Figure 16) into the square holes on the main frame weldment (B) (Figure 17).
EN 24 1460-009-002 Rev B.0