Stryker L10, Инструкции для пользователей из Соединенных Штатов

Страница: 36 / 52

32
Checking the ESST Feature
The L10 AIM Light Source is equipped with a safety feature called Electronic
Scope Sensing Technology (ESST). The ESST feature prevents exposure to
laser radiation that can cause severe eye injury and high-intensity light that
can cause accidental fires or burns. The ESST feature will work only if the light
source is used with a Stryker SafeLight cable or AIM SafeLight cable.
The ESST feature senses when the cable and SafeLight scope adapter are
separated, and it places the light source in Standby mode and disables ENV
mode. In this state, the light source reduces light output to a minimum,
protecting the user and patient from laser radiation and high-intensity light.
To verify the ESST feature is functioning properly, perform the following
test before every surgical procedure:
During the test, do not point the scope or light cable at anyone.
Do not look directly into the scope tip or the end of the light
cable. The laser radiation or high-intensity light emitted from
the light source can cause severe eye injury.
Other than performing the ESST test while observing these
precautions, the user should never disconnect a light cable
when the light source is activated.
1. Set up the L10 AIM Light Source system with a SafeLight cable (or AIM
SafeLight cable) and scope, including a SafeLight scope adapter.
2. Power on the console.
3. Activate White Light mode.
4. Activate ENV mode (if testing with an AIM SafeLight cable).
5. Disconnect the cable from the SafeLight scope adapter.
The light source should return to Standby mode (and disable ENV mode
if testing with an AIM SafeLight cable). This indicates the ESST feature is
functioning properly.
Always check to ensure that the unit has switched into Standby
mode and ENV mode is disabled before assuming ESST safety
protection. If the unit fails to return to this state, there may be
a fault with the ESST feature. In this case, do not assume ESST
safety protection, and return the unit for service.