Stryker CUB FL19H, Руководство по обслуживанию, Страница: 51 / 152

5. Using a 5/32” Allen wrench, remove the two Allen screws (A) that secure the spacer (B) and the hinge (C) of the two
access doors to the lower structural member (D) (Figure 32). Save all parts.
N No otte e -- Apply medium strength thread locker to the Allen screw threads before installation.
6. Move the lower end of the access door to the left or right and disengage it from the upper hinge (H) (Figure 32). Remove
and save both access doors. Save the spacers and hinges.
7. Using a #1 Phillips screwdriver, remove the eight screws (G) that secure the top half of the upper plastic cover (H) to the
bottom half of the upper plastic cover (X) (Figure 29). Save the screws.
8. Insert a small regular screwdriver between the two halves of the upper plastic cover. Separate the two halves. Use
caution to avoid scratching the covers or damaging the lower cover snap pins. Remove and discard the upper plastic
cover.
9. Reverse steps to reinstall.
10. Verify proper operation before you return the product to service.
L Lo ow we err p plla assttiicc cco ovve err rre ep plla acce em me en ntt
T To oo ollss rre eq qu uiirre ed d::
• #1 Phillips screwdriver
• Small regular screwdriver
P Prro occe ed du urre e::
1. Raise the rail that needs repair to the highest position.
2. Apply the brakes.
3. Using a #1 Phillips screwdriver, remove the eight screws (A) that secure the bottom half of the lower plastic cover (B) to
the top half of the lower plastic cover (C). If repairing a siderail, open the access doors to reach the two screws located
at the ends of the top half of the lower plastic cover (Figure 28 or Figure 29). Save the screws.
4. Insert a small regular screwdriver between the two halves of the lower plastic cover. Separate the two halves. Use
caution to avoid scratching the covers or damaging the upper cover snap pins. Remove and discard the lower cover.
5. Reverse steps to reinstall.
6. Verify proper operation before you return the product to service.
R Ra aiill ssu up pp po orrtt rro olllliin ng g b be ea arriin ng g rre ep plla acce em me en ntt
T To oo ollss rre eq qu uiirre ed d::
• Regular screwdriver
• Needle nose pliers
• 1/8” punch
• Bungee cords (or equivalent)
P Prro occe ed du urre e::
1. Apply the brakes.
2. Raise the head or foot section as needed and support using bungee cords. If the endrails need repair, remove the
accessory brackets.
3. For upper rolling bearings, raise the rail to the highest position. For lower rolling bearings, lower the rail to the 9 inch
position.
4. Alternately lift each side of the rail support cover (A) to lift it off the rail support (Figure 30).
5. Using bungee cords, secure the rail support.
6. Using a regular screwdriver, press and lift the two locking tabs though the holes (B) on either side of the rail support to
disengage the rolling bearing support (C) (Figure 30).
1900-009-002 Rev AA.6 49 EN