Stryker 4402-000-001, Руководство по обслуживанию

Страница: 19 / 42

F Fiig gu urre e 1 13 3 –– T To op p ccrra ad dlle e b brra acckke ett
N No otte e -- Add loctite blue threadlocker to a minimum of three threads on item L.
4. Using a rubber hammer, strike the top cradle bracket, near the gas cylinder to remove the cradle bracket from the gas
cylinder.
5. Remove the cradle assembly and supports to gain access to the gas cylinder. Set aside the cradle assembly.
6. Lift up and remove the cabinet/drawer assembly. Set aside the cabinet/drawer assembly.
7. Using a 5/32” hex wrench, remove the two screws that secure the column support bracket. Save the screws.
8. Using a 3/16: hex wrench, remove the screw (AJ) and spacer (AH) from the lower guide tube (Figure 14). Save the
screw and spacer.
F Fiig gu urre e 1 14 4 –– C Co ollu um mn n ssu up pp po orrtt b brra acckke ett
9. Using the needle nose pliers, remove the gas cylinder clip. Save the clip.
10. Grab the shaft of the gas cylinder and pull up to remove the gas cylinder from the base support bracket. Save the
washers (D), bumpers (C) and clip (F) for reinstall (Figure 15). Discard the gas cylinder.
4402-009-002 Rev AB.1 17 EN