Page 11 of 15
10. Disconnect the clamps from the battery of the vehicle if the connections are reversed (RED
reverse polarity indicator is ON and alarm is sounding) and repeat the steps 7 , 8 and 9, then
proceed to step 11.
11. Turn ON the
jumpstarter’s boosting ON/OFF switch when the correct connection indicator is on.
Crank the engine for 1
–3 seconds or until it starts, whichever is first.
12. Turn OFF the boosting ON/OFF switch after using the unit.
13. Disconnect the positive (red)(+) clamp and then the negative(black)(
–) clamp from the battery of
the vehicle.
14. Store the clamps separately after use.
15. Recharge the jumpstarter immediately after use.
⚠
WARNING
Allow the jumpstarter to cool down for at least 3 minutes after each boost.
F
ollow these instructions carefully for boosting your vehicle. The instructions may be different
from those mentioned for other boosting products or cables.
Do
not crank the engine for more than 5 seconds. The jumpstarter feature is designed only for
short term operation. Failure to comply may cause damage to the device.
⚠
CAUTION
EQUIPMENT
DAMAGE
Use only the supplied boost cables to boost a vehicle that has a 12V starting battery.
Ensure that the jumpstarter is placed away from the moving parts of the engine and jumpstarter
power ON/OFF switch is in OFF position.
Make sure the cable clamps are connected correctly to the battery terminals. A reversed polarity
connection (positive to negative) may cause a spark and damage the equipment. If the cable
clamps are connected in reverse, the reverse polarity LED indicator glows red and the audible
alarm will sound.
Ensure that the jumpstarter and the cables are away from the belts, fans or any other moving part
of the engine.
