34
Short description
TLR Series:
Mounting the light to the device:
1. Open the rail clamp tensioning bolt and position the illumination unit at the outer bottom
edge of the rail, so that the rail key matches the rail groove (see illustration below). Now
snap the unit into place by pressing it down until you detect or hear it clearly engaging.
2. Close rail clamp tensioning bolt until it is tight. The light is
¿
xed now.
3. For demounting proceed in reverse order.
Operating the light:
1. Tap the left side of the paddle switch down = constant light as long as you hold it down.
After release the light goes out.
2. Tap the left side of the paddle switch down and immediately re-press within 0.4 s and
hold = strobe mode as long as you hold it down.
3. Tap down the right side of the paddle switch = constant light. Tap again to stop
illumination.
4. Tap down the right side of the paddle switch and immediately re-press within 0.4 s =
constant strobe mode. Tap again to stop illumination.
13. Lighting (optional expansion possibility)
The lighting unit is optional and not offered by HURST.
The illustratioin shows a typical installation of a
À
ashlight as an overview.
Pay always attention to the separate instruction manual provided from the supplier or
manufacturer to mount and operate your
À
ashlight unit as intended.
The light must be separately ordered by the customer at a deliberate supplier.
HURST recommends the TLR Series offered by STREAMLIGHT.
WARNING / CAUTION / PLEASE NOTE!
The light or LASER beam of the lighting unit can cause seriouos injuries or lead
to blindness.
Any accessories attached to the rail are used at the risk of
the user.