12
PART 2 • English
7.2.1.3 Receiver Information:
This menu contains valuable information about the model number, the software version and our web
address www.strong.tv. A customer support agent might ask for the information given in this screen.
Press EXIT to leave this menu.
7.2.1.4 User setup:
Within the User Setup menu you can configure the audio and video outputs of your receiver. Use
pq
to
highlight the setting you wish to change and
tu
to change the value of the highlighted setting. Press
ok to display a list of all available options, for the chosen setting.
Video Output Via:
Use this option to configure your connection to the TV set. Select SCART if you
are connect by Scart cable or select HDMI/YUV if you are connect by HDMI or
Component cable to TV set. Be aware that HD+ services / channels can only be
seen if correct selection is made!
Resolution:
If you have selected HDMI/YUV in above, then you can select the resolution of
HDMI output. Available options are: 1080i, 720p, 576p and 576i.
Aspect Ratio:
If you have selected SCART in above, then you can select the according aspect
ratio of your TV set. Available options are: 4:3 and 16:9.
Display16:9 Event:
Use this option to set the preferred way of conversion from 16:9 broadcasts
in 4:3 TV set. You can choose between the following options: Letter-box (the
full 16:9 picture will be displayed on your 4:3 TV set with black bars above
and below the picture.), Pan and scan (The centre of the 16:9 picture will be
displayed as full-screen on your 4:3 TV set) and Just Scale (Combination of
Letter-box and Pan and scan.)
SCART Mode:
Select RGB for the best picture quality or CVBS in case your TV doesn’t support
RGB. In case you have set HDMI/YUV in the above setting, your Scart output
will be switched to CVBS automatically.
Info banner Timeout:
Defines the time after which the OSD banners time out. Possible settings are:
2~12 seconds.
TV List Timeout:
Defines the time after which the TV list time out. Possible settings are:
2~12 seconds.
Dolby Digital Option:
Select ON if you using an optical connection to you digital amplifier to enjoy
Dolby Digital*, in case the selected channel support this. Select OFF if you not
use this option.
Subtitle Control:
Use this option to set the preferred way of subtitles support. Select Auto
to switch subtitles automatic on if they are available, or select Manual to
select ON or OFF. In viewing mode you can press the oPT button to enter
this setting.
Advanced setup
In User Setup menu you can press the blUE button to enter the advanced settings. It is strictly
recommend not to change any of these settings unless you are absolutely sure and an advanced user.
LNB Power:
Allow you to switch OFF or ON power of LNB.
DiSEqC repeat:
Repeat command for commit switches (1, 2 and OFF)
Power save Mode:
This setting will set the receiver in low power mode during standby in order to
reduce standby power below 2 watt. If you select this option to ON be aware
that wakeup of your receiver will take more then one minute.
Pre Wakeup (min.):
Here you can set the pre wake up time for your receiver if a Timer/recording is
configured and you are using the Power save Mode during Standby (3, 4 and 5
min.).
HDCP Setting:
To switch ON or OFF the control key for HD screens. If you select OFF will only
low video resolution available.
Press ok to confirm and to exit this menu.
