10
PART 2 • English
7.1 Channel setup
The installation menu allows you to change satellite settings and to search for channels. It consists of
the following sub-menus: Channel Scan and Channel Editor. Choose the desired sub menu with
pq
and
press ok to advance.
7.1.1 Channel scan
Use this menu to select the satellite, change the settings for the used antenna and start scan process for
searching the channels.
Satellite:
Use
pq
to highlight Satellite and
tu
to select the satellite you wish to
change the settings for. To display the list of all available satellites, press ok. At
the end of this list you can find Newsat1 -10. Those can be used to configure a
new satellite setup.
LNB:
Select LNB type if you are using another LNB as Univ.LNB model. As this is the
common used LNB, it is set per default.
DiSEqC:
If you are using a DiSEqC switch in order to connect more dishes, select the
correct used switch type. Select DiSEqC 1.0 for maximum 4 dishes. DiSEqC 1.1
for maximum 16 dishes and select None if you don’t use any switch.
DiSEqC Port:
If you are using a DiSEqC switch you need to set the correct DiSEqC port which
belongs to the connected satellite.
Transponder:
Select this option, if you want to scan manually or check the signal on the
desired transponder frequency. Use
tu
to select the transponder of you
choice, or open the Transponder list of the selected satellite with ok.
Motor Control:
If you are using a DiSEqC motor to install multiple satellites. Select the
according setup type with
tu
. Select DiSEqC 1.2 for manual setup of each
satellite or select goTo-X for automatic calculation after you have adjusted the
0-position and corresponding Cartesian coordinates of your location.
note:
Please consider that goTo X must be supported from your Motor as well!
Motor Setting:
Here you can setup the necessary settings according to the used Motor
Control. Adjust and store these settings correctly, in order to be able to proceed
with Search Start.
Search Start:
Before you start the scan process please make sure that all settings are made correctly and Strength and
Quality bars are showing green colours. If the Strength and Quality bars showing red or yellow colours,
then the satellite signal is too weak. Please try to adjust your satellite dish first, to improve the signal.
At the first time installation there was performed the HD+ Channel Scan from APS. After this successful
scan process you can choose following of the additional possibilities:
Select Search Start and press ok.
A new menu will be opened on the right side of your screen, called “Options”. Use this menu to perform
an Automatic, TP (manual) or Network channel search on one or more satellites. Use
tu
pq
to
highlight and ok to select an option.
Start Auto Scan:
Use this option to perform a full channel scan on the selected satellite, under
the below mentioned conditions.
TP Search Start:
Use this option to perform a scan on the selected transponder only.
Network Search Start:
Use this option to receive new launched channels from the selected satellite.
The receiver will perform an additional search for channels from the NIT table
(NIT= Network Identification Table).
Search Mode:
Select All to scan all channels including scrambled channels or FTA to scan for
Free-To-Air channels only.
NIT Search:
Select OFF if you don’t want to perform a network search or set ON to perform
a network search.
