Stromag EDB Series, Инструкция по монтажу

Страница: 90 / 104

6.5.2 Assembly and electrical connection of the brushes in the box-type holder
Fitting the box-
type holder 1. Mount the box-type holder onto the insulation bolts,
which are attached to a holder or a housing surface.
This requires a stable and low-vibration construc-
tion.
Fig. 18
Adjusting the
distance 1. Adjust distance between box-type holder and slip
ring to 2 mm.
NOTE
For sizes 02 to 10, the electrical connection
occurs directly on the box-type holder
through an M4 connection bolt. The custom-
er's connection cable must therefore be
equipped with a soldering cable shoe, for ex-
ample, form A DIN 46211, see section 2.5.
2. Align the carbon brushes radially to the slip ring cen-
tre.
Fig. 19
6.5.3 Assembly and electrical connection of the brushes in the spark-type brush holder
Mounting the
spark-type brush
holders The spark-type brush holders are screwed directly into
the machine housing.
NOTE
If this is not feasible, strong brackets need to
be screwed onto both sides.
The mounting structure should always be
stable and low in vibrations.
The displayed figure should only be under-
stood as an example.
1. Align the bronze fabric brushes radially to the slip
ring centre. A deviation of 2° is permitted.
Fig. 20
32
Mounting instructions Electromagnetic multi-disc clutch EKE/EKB, EDE/EDB • No. 500-00000 C • 10/2017