Strobel VEB100-6, Инструкции механика

Страница: 33 / 42

29
MA_VEB100-6_A2_180618_en
3.11.2
At works the tape guide is set to a standard tape width of 15 mm.
Tape guide (Fig. 14)
However, tape guide (7) can be set to tape widths from 15 to 25 mm.
But depending on the required tape width different blowing nozzles have to be
used and are available as optional extras.
Setting the tape width of the tape guide:
- Set the tape guide to the required width.
- Tape guide (7) is infinitely adjustable by turning threaded spindle (8).
- turning to the left
⇒
larger tape width
- turning to the right
⇒
smaller tape width
The distance between tape guide and tape should be 1 mm minimum.
- Replacing the blowing nozzle:
- Loosen and remove screw (9).
- Replace the blowing channel.
- Screw-on and tighten screw (9).
3.11.3
Driving roll (10) is pressed towards the tape by means of part (11) and is driven
by electric motor (12). By means of the tape blowing device the tape is blown
under the needle plate.
Tape feed (Fig. 14)
The fed tape length should always be long enough to allow the feed dog to
catch the tape for sewing.
The delaying time and the switch-on time of the tape feed can be altered (that
is, the given tape length) (see sewing drive instruction).
3.11.4
During the tape feed process the air nozzle in the blowing channel blows the
tape under the needle plate.
Tape blowing device (Fig. 14)
The delaying times of the tape blowing-in device can be altered (see sewing
drive instructions).
Also the air quantity can be regulated by means of a throttle.