Strobel VEB100-6, Инструкции механика

Страница: 32 / 42

28
MA_VEB100-6_A2_180618_en
3.11
3.11.1
Tape guide complete
Upper knife (1) should move smoothly and scissors like over lower knife (2).
Tape cutter (Fig. 14)
The two edges should not overlap more than approx. 1 mm maximum.
Adjustment:
- Turn solenoid valve MV2 manually by 90° to the right (tape cutter is
switched on pneumatically).
- Open screw (3) at lever (4).
- Set shaft (5) with upper knife (1) in a way that the two knife edges do not
overlap more than approx. 1 mm.
Attention!
There should be no lateral force on fork head (6) or shaft (5)
respectively.
- Tighten screw (3).
- Turn solenoid valve MV2 manually by 90° to the left (tape cutter is
switched off pneumatically).
The delaying time and switch-on time of the tape cutter can be altered (see
sewing drive instruction).
Fig. 14