Strima AUDACES Jet Lux Plus, Инструкция по эксплуатации

Страница: 7 / 42

AUDACES
7
Chapter 2 System Requirements
2.1 Connecting of power source
An independent power with a proper earth grounded system is required.
The power supplier shall not be shared with other machines or devices. The
lightning preventing system is highly recommended. The operating voltage of
the plotter can be seen in the label on the back of the plotter. The voltage of the
AC power could not fluctuate beyond a range of ±8
％
. Please supply power for
the plotter with a 500W or higher UPS. Please confirm whether the supply
voltage matches with the marked voltage on the plotter! About the supply
voltage fluctuates cannot surpass 8%, please use the UPS 500W or above to
provide the power for the plotter.
The AUDACES plotter is shipped with a three-plug power cable. The
cable should always be used with a socket that is equipped to receive the
pronged plug.
Make sure the plotter is turned off. Plug one end of the power cable into the
connector of the plotter. Plug the power cord into an appropriate power outlet.
.
Turn the power switch to ON, the plotter will send out the short ' di ' beep,
indicated that the plotter self-check is successful, and status of the plotter is
normal. If the plotter does not give the short ' di ' beep, turn off the plotter and
wait for at least 10 seconds, then turn on the plotter again. Under normal
conditions, the indicator light on the control panel comes on.
Attention! Wait for at least 10 seconds to turn on the plotter again
after each normal shutdown.
2.2 Computer
Minimum requirements: CPU PII-350
，
64M RAM
，
10G HD
，
CD-ROM
Drive
，
Floppy Drive, 15” Display
Recommended system setup: CPU P4-1.7G
，
256M RAM
，
40G HD
，
CD
，
Floppy Drive
，
17” Display
Operating system
：
Windows98, Windows2000, Windows XP
Warning: If the voltage of power source is not the same as
the marked voltage on the plotter, please contact your
supplier.