Strima AUDACES Jet Lux Plus, Инструкция по эксплуатации

Страница: 12 / 42

AUDACES
12
Chapter 4 Loading Printing Media
4.1 Loading of a new feed roll
Switch off the plotter, stand behind and face the plotter, and pull the feed
roll to the left by hand with a little strength. As the right side of the feed roll is
separated from the coupling, lift up the feed roll and take it off. Loosen the
internal hexagonal screws on the paper hub of the feed roll with a 5mm internal
hexagonal wrench and take off the old paper roll. Load a new paper roll, install
the paper hub, grip the paper roll tightly and beat it gently until it is not loose
between the paper hub and the paper roll. Move the paper roll (together with
the paper hub) and make the plotting paper in the middle of the feed roll. Then
tighten the internal hexagonal screws on the paper hub with the internal
hexagonal wrench. Install the feed roll to the plotter.
4.2 Paper loading of the take-up roll
Switch on the power, make the feed roll unload some paper (about 1m),
and then switch off the power. Open the cover of the plotter to a steady
position. Pull paper between the encoder-roller and the main beam, hold the
edge of paper and rock it gently to the left and to the right, until the paper is
level on the whole. Then cut surplus paper according to the position of the
take-up roll. Prepare 3-5 rubberized tapes and each is of 3cm-4cm in length. At
first, stick a rubberized tape on the center of paper and pull the tape to stick on
the take-up roll with a little strength. Then stick on other prepared tapes from
the center to both sides in proper order. After that, check whether the paper is
level. Switch on the power of the plotter, use the tension roll to press paper and
put it to the slide slot.
Up to this point, paper loading of the take-up roll is complete and the plotter
is ready for plotting.