Stricker Crossbike Series, Инструкция по эксплуатации

Страница: 23 / 36

R&E Stricker Reha-Entwicklungen GmbH
21
Power Assist Devices
Operation
Fig. 34: Key switch on battery and control
Switch on the control at the control unit. The on
/ off switch with the on / off symbol is slightly
highlighted in the middle of the control panel. You
cannot remove the key when it is switched on ( Fig.
33 ).
Fig. 35: Control unit on the left handle
Press and hold the power switch on the control
unit for 3-5 seconds until the Stricker logo
appears on the display. The speed levels 1-5 are
controlled using the +/- buttons on the control unit.
These are shown on the display below the speed
indicator( Fig. 36 ). Press or turn the thumb throttle
or twist throttle to accelerate ( Fig. 35 ).
Fig. 36: Display on the handlebar
The current battery charge status can be read in
the upper right corner of the display. The number
next to the state of charge describes the battery
voltage in volts ( Fig. 36 ).
The Pushing aid can be activated by holding the
“-” key on the control unit. As a result, the power
assist device travels at a speed of 5 km / h as long
as the button is held.
Fig. 37: Bike computer reset
You can reset the travel data by simultaneously
pressing and holding the +/- buttons on the control
unit. This will set the daily mileage and driving time
to 0 ( Fig. 37 ).
If your display is equipped with a time, you can set
this..Briefly.press.the.M.button.twice.in.succession.
to access the display settings. There select the
menu item “Clock”.