Stricker Crossbike Series, Инструкция по эксплуатации

Страница: 20 / 36

18
R&E Stricker Reha-Entwicklungen GmbH Power Assist Devices
Operation
Switch on the battery with the main switch on the
battery. You will know that the battery is switched
on when the lamp on the battery lights up ( Fig. 25 ).
Turn the key switch with the key to the „ ON “
position ( Fig. 21 bzw. Fig. 22 ). Remove the key and
stow it safely so as not to lose it while driving.
Turn the right handle to accelerate.
The brake lever on the right side of the handlebar
automatically interrupts the drive electronics when
actuated. You therefore cannot operate the right
brake lever and accelerate at the same time.
The brake lever on the left side of the handlebar
has no breaker contact. You can use the left brake
lever for starting uphill.
11.1.2 Starting uphill
If you have stopped on an incline and want to start
again, you may roll backwards and not be able to
start. In order to be able to start despite the slope,
lean forward to put more weight on the front wheel.
Press and hold the left brake lever. At the same
time, carefully apply the accelerator. Reduce the
pressure on the brake while slowly increasing the
throttle. As soon as you feel that you are moving
in the direction of travel, you can release the brake
completely.
11.1.3 End of ride
Switch off the battery using the main switch on the
battery. You will know that the battery is off when
the light on the battery is not lit. ( Fig. 25 ).
Turn the key switch on the control unit with the
key to the „ OFF “ position. ( Fig. 21 bzw. Fig. 22 ).
Remove the key and store it in a safe place. Make
sure it is not within reach of unauthorised persons
or children.
11.1.4 Optional extras: lights/horn and
cruise control/reverse gear.
Fig. 26: Left: Light (red) and horn (green); Right: reverse gear
(red) and cruise control (green).
To switch on the light on the traction unit, press the
red button with the light symbol on the left handle.
Press the button again to switch the light off. Press
the green button with the horn symbol to activate
the horn.
To activate reverse gear, press the red button
on the right handle. Press the button again to
disengage reverse gear. Press the green button
to activate the cruise control. When the cruise
control is activated, it saves and maintains your
current driving speed. Press the button again to
deactivate cruise control. Pressing the brake with
breaker contact (brake on the right handle) also
deactivates the cruise control. Should you use the
throttle handle while the cruise control is active,
the traction unit will not accelerate. If the throttle
grip is turned back to the zero position after
accelerating, this will deactivate the cruise control.
WARNING
Use.cruise.control.only.when.the.traffic.situation.
permits. Be ready to deactivate cruise control at
any time with the brake with breaker contact.
11.1.5 Optional equipment: 2 Lipo
batteries with 2 change-over
switches
With this optional equipment for the Lipo Lomo you
get a towing device with two batteries on the fork
and a control box with two toggle switches. The
standard battery holder on top is omitted with this
equipment.