Stricker Crossbike Series, Инструкция по эксплуатации

Страница: 11 / 36

R&E Stricker Reha-Entwicklungen GmbH
9
Power Assist Devices
Fitting the handbike to the wheelchair and the rider
NOTE
To perform all adjustments, place the handcycle
and your wheelchair securely on level, solid
ground. Make sure there is enough space and
light to carefully implement the adjustments.
7.2 Adjusting the inclination of
the headstock tube
WARNING
Make sure that the corner brackets secured by the
S1L and S1R screws do not slip out of the cross
tubes. Do not use the insertion depth of the corner
brackets to adjust the width of the clamping
device.
Loosen the S1L and S1R screws using the Allen
key (SW 6) provided. Turn the longitudinal tubes
to the desired angle to the control bearing tube.
A.guide.value.for.this.is.90°..For.fine.adjustment.
of the crank position, you may have to adjust the
angle again. Lightly tighten the S1L and S1R bolts
( Fig. 2 ).
After completing all adjustments, tighten the S1L
and S1R screws to a torque of 30 Nm.
NOTE
If you make adjustments to the inclination of the
headset tube while the handbike is coupled to the
wheelchair, also loosen the S3L and S3R screws
to prevent tension in the frame. Tighten them
again afterwards with a torque of 30 Nm.
7.3 Adjusting the length and
width of the clamping device
To adjust the length of the longitudinal tubes and
the angle of the clamps, loosen screws S3L and
S3R. Make sure that the length of the longitudinal
tubes is always set identically on both sides ( Fig.
3 ).
Adjust the angle of the clamps according to the
wheelchair frame at the clamping position. This is
especially important for wheelchairs with V-shaped
frames. Lightly tighten the S3L and S3R screws.
After completing all adjustments, tighten the S3L
and S3R screws to a torque of 30 Nm.
NOTE
If you make adjustments to the length of the
longitudinal tubes while the handbike is coupled
to the wheelchair, also loosen the S2L and S2R
bolts to avoid tension in the frame.
To adjust the width of the clamping device, loosen
the S2L and S2R screws. Adjust the clamping
device to the width of the wheelchair frame. Make
sure to set the same angle to the cross tube on
both sides. Lightly tighten the S2L and S2R screws.
After completing all adjustments, tighten the S2L
and S2R screws to a torque of 30 Nm.
Fig. 3: Setting the default frame
7.4 Coupling the handbike to the
wheelchair for the first time
Fig. 4: Clamp fixed to the wheelchair frame
Fig. 4 .shows.how.the.clamps.are.correctly.fixed.
to the wheelchair. The position clamps mounted
under the clamps ensure that the clamp always