Strebel 40S-70, Руководство по установке

Страница: 13 / 38

9
Overview
Boiler room/air supply/installation site
Checks following transport
Boiler room
With regard to the equipment in
the boiler room, the respective
local building regulations, the
applicable standards and fire
ordinances as well as fire
protection regulations are
authoritative. The installation
room must be frost-proof and
well ventilated. Any damage to
the boiler which occurs if these
requirements are not met, will
not be covered by the warranty.
Air supply
It must be ensured that there is
an adequate supply of fresh air
to the boiler room, so that the
combustion air required for the
operation of the installed
burners, can be replaced and
the operating personnel are not
endangered by a lack of oxygen!
The supply air must not be
contaminated by aggressive
vapours (e.g. hairspray,
percholoroethylene, carbon
tetrachloride).
Installation site
The boiler must be installed
levelly on a fortified floor. A
plinth is not required. For
unhindered operation and
maintenance of the boiler unit, it
must be ensured that there is a
passage width of at least 80cm
(type 20-70) / 130cm (type L) in
front of and on at least one side
of the boiler, and at least 50 cm
behind the boiler.
On the top side of the boiler, at
the back, there is a cleaning
aperture.. Therefore, the ceiling
clearance must be at least 60 to
80cm. Do not lay any pipes in
the vicinity of the cleaning lid
(15)!
Checks following transport
Attention must be paid to the
following points after transport
into the boiler room and before
commencing assembly:
- position of the lining stones in
the flame duct (12)
- position of the insulating stones
in the ashes door (13)
- sealing integrity of the doors;
the doors are adjustable on both
the hinge and closure sides
- remove all components from
the filling chamber, check them
against the packing list and lay
them out ready for assembly.